The Iron (III) Thiocyanate Complex
Purpose of the Experiment
To determine the chemical formula of a complex ion and measure its formation equilibrium constant.
Equipment
SpectroVis spectrophotometer, LabQuest controller, teflon stylus, cuvette, 25-mL burette (3), burette clamp, ring stand, 50-mL beaker (3), small plastic beakers.
Reagents
potassium thiocyanate (KSCN for SCN-) = 0.00200 M solution, iron (II) nitrate (Fe(NO3)2 for Fe2+) 0.00200 M solution and 0.200 M solution, nitric acid (HNO3) 1M solution and 0.4 M solution.
Introduction
The iron (III) thiocyanate complex is labile and only exists in solution. The equilibrium concentrations of the complex and ferric thiocyanate are established if the reactants, iron (III) ion, Fe3+, and thiocyanate ion, SCN-, are initially present in constant molar ratios. Metal cations exist in aqueous solution in the form of complexes with water molecules. In the case of the iron (III) cation, with a coordination number of 6, it is in the form of the hexaaquairon (III) complex cation. The reaction between Fe3+ and SCN- in an aqueous solution is indicated below:
[Fe(H2O)6]3+ + SCN- = [Fe(H2O)5SCN]2+ + H2O
Since the iron (III) and thiocyanate ions contribute little to the absorbance of visible light at a wavelength of 450 nm, it is possible to use the intense absorbance of the deep red iron (III)-thiocyanate complex at 450 nm to measure its concentration without interference from the uncomplexed ions. For example, the composition of the complex can be determined by observing the molar ratio of the thiocyanate ion to the iron (III) ion that produces the maximum yield of the complex. Since neither the initial concentration of the iron (III) ion nor the thiocyanate ion is kept constant while the molar ratios of the two are varied, the composition of the complex ion is determined by the molar ratio which produces the maximum absorbance. After determining the composition of the complex ion, data will be used to construct a Beer's Law plot that relates the concentrations of the complex to its absorbance, which will allow the concentrations of the complex to be calculated.