F. (30) Consider a rivet hole in 0.050-inch thick, 7075-T6 skin on the bottom of a wing. The preliminary stress analysis shows the rivet hole is subjected to an essentially uni-axial state of stress which varies during a nominal flight from -8 ksi to +20 ksi. The fatigue notch sensitivity is assumed to be 3.4, and the skin has been found to have fatigue properties similar to the rolled bar product. Find: a. the average number of times this rivet hole can be exposed to the "ground-air-ground" (GAG) stress cycle, that is, from -8 to 20 ksi, before fatigue failure b. the damage done (as a fraction of the fatigue life) for the GAG cycle c. the damage done for the stress spectrum shown d. the number of flights, with the stress spectrum shown, expected until fatigue failure e. What is the meaning of the "fatigue" life estimated from S-N curves in the MMPDS (Mil Hdbk 5).
Added by Carlos P.
Close
Step 1
The S-N curve is a plot of the stress amplitude versus the number of cycles to failure. The stress amplitude for the GAG cycle is (20 - (-8))/2 = 14 ksi. Looking up this value on the S-N curve for 7075-T6, we can find the corresponding number of cycles to failure. Show more…
Show all steps
Your feedback will help us improve your experience
Labs
Want to see this concept in action?
Explore this concept interactively to see how it behaves as you change inputs.
Key Concepts
Recommended Videos
The analysis of the cyclic stresses on part of the landing gear of an aircraft shows that during each flight it is subjected to the following stress history: 100,000 cycles at ± 50 MN/m^2, 10,000 cycles at ± 100 MN/m^2, 500 cycles at ± 150 MN/m^2, 200 cycles at ± 180 MN/m^2, 100 cycles at ± 185 MN/m^2, 50 cycles at ± 200 MN/m^2, and 10 cycles at ± 210 MN/m^2. If the S-N curve for the part material is given by S = 500 N^(-0.064), where S is in MN/m^2, estimate how many flights this component can withstand before fatigue failure occurs.
Sri K.
A manufacturer informs a customer's design engineers that the mean tensile strength of its rivets is at least 3000 pounds. A test is set up to measure the tensile strength of a sample of rivets, with the null and alternative hypotheses, H0: μ ≥ 3000 and H1: μ < 3000. For each of the following individuals, indicate whether the person would tend to prefer a numerically very high (e.g., α = 0.20) or a numerically very low (e.g., α = 0.0001) level of significance to be specified for the test. a. The marketing director for a major competitor of the rivet manufacturer. b. The rivet manufacturer's advertising agency, which has already made the "at least 3000 pounds" claim in national ads.
Robin C.
Adi S.
Recommended Textbooks
University Physics with Modern Physics
Physics: Principles with Applications
Fundamentals of Physics
Transcript
Watch the video solution with this free unlock.
EMAIL
PASSWORD