00:01
Hello, so for the first question here on the maximum degrees between pull points in a conduit run, well in electrical installations a conduit run between pull points or boxes is typically going to be limited to a total of 360 degrees in bends.
00:22
This means that the sum of all the bends in one continuous run of conduit should not exceed 360 degrees before reaching a pull point, junction box, or another access point.
00:36
And then the second question here, the main reason for making a saddle bend in conduit.
00:41
Well a saddle bend is often used in conduit work when there's going to be an obstruction such as another conduit or structural feature and you need to make the conduit go over or occasionally under it without rerouting the entire run.
01:00
So the saddle bends allow the conduit to be raised or lowered temporarily to clear the obstruction and then return to its original level.
01:18
And then third, so the factors to determine wind bending conduit segments with a hydraulic bender.
01:26
So we have the type of the conduit material...