Question

The lap joint is connected together using a 1.20-in.-diameter bolt. (Figure 1) Part A If the bolt is made from a material having a shear stress-strain diagram that is approximated as shown in (Figure 2), determine the permanent shear strain in the shear plane of the bolt when an applied force of P = 150 kip is removed. Express your answer in radians to three significant figures. $\gamma_P$ = rad Incorrect; Try Again; 5 attempts remaining

Name: the lap joint is connected together using a 120 in diameter bolt figure 1 part a if the bolt is made from a material having a shear stress strain diagram that is approximated as shown in fig 76682
Uploaded: 2023-03-12T03:47:23-08:00
Duration: 3 min 43 s
Channel: Sri K
Description: the lap joint is connected together using a 120 in diameter bolt figure 1 part a if the bolt is made from a material having a shear stress strain diagram that is approximated as shown in fig 76682

          The lap joint is connected together using a 1.20-in.-diameter bolt. (Figure 1)
Part A
If the bolt is made from a material having a shear stress-strain diagram that is approximated as shown in (Figure 2), determine the permanent shear strain in the shear plane of the bolt when an applied force of P = 150 kip is removed.
Express your answer in radians to three significant figures.
$\gamma_P$ = rad
Incorrect; Try Again; 5 attempts remaining

the lap joint is connected together using a 120 in diameter bolt figure 1 part a if the bolt is made from a material having a shear stress strain diagram that is approximated as shown in fig 76682

Added by Lindsey A.

University Physics with Modern Physics

Hugh D. Young 14th Edition

Instant Answer

Solved by Expert Sri K

03/12/2023

Step 1

The shear stress is given by the formula: $\tau = \frac{V}{A}$ where V is the shear force and A is the area. In this case, the shear force is half of the applied force P, so $V = \frac{P}{2} = \frac{150}{2} = 75$ kips. The area is the cross-sectional area of the Show more…

Show all steps

Thanks for your feedback!

The lap joint is connected together using a 1.20-in.-diameter bolt. (Figure 1) Part A If the bolt is made from a material having a shear stress-strain diagram that is approximated as shown in (Figure 2), determine the permanent shear strain in the shear plane of the bolt when an applied force of P = 150 kip is removed. Express your answer in radians to three significant figures. $\gamma_P$ = rad Incorrect; Try Again; 5 attempts remaining