Question 1 of 37 Time Spent 00:00:33 Next > You need to connect a workstation to a switch using a regular port on the switch (not an uplink port). The switch does not support auto-MDI. Which type of cable should you use? Straight-through Crossover Rollover Loopback Question 2 of 37 < Back Next > Which of the following IPV6 addresses is equivalent to the IPV4 loopback address of 127.0.0.1? FF02 :: 1 :: 1 FE80 :: 1 ::
Question 3 of 37 Time Spent UU:04:19 < Back Next > You manage a network with two locations (Portland and Seattle). Both locations are connected to the internet. The computers in both locations are configured to use IPV6. You'd like to implement an IPV6 solution to meet the following requirements: . Hosts in each location should be able to use IPV6 to communicate with hosts in the other location through the IPV4 internet. . You want to use a site-to-site tunneling method instead of a host-to-host tunneling method. Which IPv6 solution should you use? ISATAP 6to4 tunneling Teredo tunneling 4to6 tunneling Question 4 of 37 < Back Next > You are configuring the DHCP relay agent role on a Windows server. Which of the following is a required step for the configuration? Configure the Windows server to be on the same subnet as the DHCP server. Use the ip helper-address command to specify the remote DHCP server. Specify which server network interface the agent listens on for DHCP messages. Connect an RFC 1542-compliant router to the Windows server.
Question 5 of 37 < Back Next > Which of the following standards does a rollover cable typically use? RS232 RG58 RG6 RJ11 Question 6 of 37 < Back Next > Which port does the relay agent use when it sends DHCP information back to the client? 67 80 68 53