Section 2: Lab SU-5b Trunk-Based Inter-VLAN Routing Configuration 192.168.10.1 Gig0/0/1 192.168.20.1 Gig1/0/ Gig1/0/11 3650 .- 26 s Gig1/0/7 Fa0 I PC-PT PC-A Ethemet PC VLAN 10 192.168.10.3 Gig1/0/5 3650-50 s Gig1/0/24 Fa0 PC-PT PC-B VAN PC VLAN 20 192.168.20.3
Part 1: Build the Network and Configure Basic Device Settings Step 5: Reconfigure the Management VLAN for each switch S3 × Physical Config CLI Attributes S3 [config) # 53 | config) # 53 [config) # S3 [config) # S3 [config) # S3 [config) # 53 [config) # S3 [config) #vlan 99 53 [config-vlan) #name Management S3 [ config-vlan) #exit 53 [config) fint vlan 10 53 [config-if) #no ip add 53 [config-if) #no ip address S3 [config-if) #exit 53 [config) #no int vlan 10 53 [config) # &LINK-5-CHANGED: Interface Vlan10, changed state to administratively down IOS Command Line Interface \LINEPROTO-5-UPDOWN: Line protocol on Interface Vlanlo, changed state to down 53 [config) fint vlan 99 S3 [config-if) # BLINK-5-CHANGED: Interface Vlan99, changed state to up \LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan99, changed state to up S3 [config-if) #ip add S3 [config-1f) #ip address 192.168.1.11 255. 255. 255. 0 S3 [config-if) #~Z 53# %SYS-S-CONFIG_I: Configured from console by console 53 53# S3#ping 192.168.1.12 Type escape sequence co abort. Sending 5, 100-byte ICMP Echos to 192.168.1.12, timeout is 2 seconds: Success rate 18 0 percent (0/5) 534 S4 - 0 × Physical Config CL Attributes 54 (config) # 54 (config) # 54 (config) # S4 (config) # S4 (config) # 54 (config) #vlan 99 54 (config-vlan) #name Management 54 (config-vlan) #exit 54 (config) #int vlan 10 S4 (config-if) #no ip add S4 (config-if) #no ip address 54 (config-1f) #exit 54 (config) #no int vlan 10 54 (config) # &LINK-5-CHANGED: Interface Vlan10, changed state to administratively down IOS Command Line Interface \LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan10, changed state to down 54 (config) #int vlan 99 54 (config-1f) # &LINK-5-CHANGED: Interface Vlan99, changed state to up \LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan99, changed state to up 54 (config-if) #ip add Incomplete command. 54 (config-if) #ip address 192. 168. 1. 12 255.255. 255. 0 S4 (config-if) #exit S4 (config) # 54 (config) #ip default-gateway 192.168. 1.1 54 (config) #exit 54# &SYS-5-CONFIG I: Configured from console by console S4#ping 192.168.1.11 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.1.11, timeout ig 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max - 0/0/2 ma 54#
S3 - × Physical Config CLI Attributes IOS Command Line Interface S4 - × Physical Config CLI Attributes IOS Command Line Interface S4 [config) # 54 [config) # S4 [ config) # S4 [ config) # 54 [config) # S4 [ config) #vlan 99 54 [ config-vlan) #name Management 54 [ config-vlan) #exit S4 [ config) #int vlan 10 S4 [ config-1f| fno ip add 54 [ config-if) #no ip address S4 [ config-if| #exit S4 [ config) #no int vlan 10 S4 [config) # %LINK-5-CHANGED: Interface Vlan10, changed state to administratively down \LINEPROTO-5-UPDONN: Line protocol on Interface Vlanlo,