00:02
So to make a bolt meter, a resistor our series should be placed in series with the existing meter, which is shown by the green dot.
00:19
So this combination inside the green dotted perimeter is the existing meter.
00:28
And in order to make a volt meter, a resistor, let's call it.
00:33
Series should be connected with this whole connection.
00:37
So that's what we did as shown in the circuit diagram.
00:43
So this is done so that the desired scale voltage corresponds to the full scale current of the galvanometer.
00:52
Now we know that 25mphor produces full scale diffraction of the galvanometer.
00:58
So the voltage drop across total meter must be 25 when the current through the meter is 25 millie ampere.
01:13
So v full scale, which is vfs here, you know that that is equal to i full scale minus the equivalent resistance of the whole circuit diagram.
01:38
So this red, whatever is inside this, inside the red dotter line.
01:48
We are taking the equivalent resistance of those resistors inside the red dotter line.
01:55
Now we discussed that v full scale must be equal to, so this is the voltage drop, the full scale voltage drop, so that is equal to 25 volt.
02:20
When the current is 25 millie -amper, we need to convert that into amperes so that all units are consistent and this is done because we know that this current produces a full -scale deflection of the galvanometer that's here so the voltage drop across the total meter like across these two points should be equal to or must be 25 volt when the current through the meter is 25 mllampeer now let's solve this equation.
03:21
So what's r equivalent? let's find that as well.
03:28
So we have r series connected in series with these two resistors which are connected in parallel...