Question
You need to select a line code that will only be used to send the bit sequences 10101010 and 00111100 . Which of the lines codes shown in Fig. 2-14 is not a good candidate? Consider both bandwidth efficiency and clock recovery.
Step 1
First, let's recall the main characteristics of a good line code for digital communication: - Bandwidth efficiency: The line code should occupy the least possible bandwidth for a given data rate. - Clock recovery: The line code should allow the receiver to Show more…
Show all steps
Your feedback will help us improve your experience
James Kiss and 94 other educators are ready to help you.
Ask a new question
Labs
Want to see this concept in action?
Explore this concept interactively to see how it behaves as you change inputs.
Key Concepts
Recommended Videos
Select the correct alternative from the given choices. Let us suppose that we want to read 2048 bytes in programmed I/O mode of CPU. The bus width is 32 -bits. Each time an interrupt occurs from Hard disk drive and it taken $4 \mu$ sec to service it. How much CPU time is required to read 2048 bytes? (A) $512 \mathrm{msec}$ (B) $768 \mathrm{msec}$ (C) $1024 \mathrm{msec}$ (D) $2048 \mathrm{msec}$
Computer Organization and Architecture
Memory Interface, I/O Interface
Select the correct alternative from the given choices. A system is based on a 16-bit microprocessor and has two I/O devices. The $\mathrm{I} / \mathrm{O}$ controllers for this system use separate control and status registers. Both devices handle data on a one-byte-at-a time basis. The first device has two status lines and three control lines. The second device has three status lines and four control lines. How many 16-bit I/O control module registers do we need for status reading and control of each device? (A) 1,2 (B) 2,1 (C) 2,2 (D) 1,1
Select the correct alternative from the given choices. A 3-to- 8 decoder is shown below All the output lines of the chip will be high except pin 8 , when all the inputs 1,2, and 3 (A) are high; and $G, G_{2}$ are low (B) are high; and $G$ is low $G_{2}$ is high (C) are high; and $G, G_{2}$ are high (D) are high; and $G$ is high $G_{2}$ is low
Digital Logic
Combinational Circuits
Transcript
Watch the video solution with this free unlock.
EMAIL
PASSWORD