Problem #13
A continuous rotary dryer is used to dry 700 [kg/h] of wet wood chips at atmospheric
pressure. The chips enter at 19 [°C] with a water content of 40% by mass. Hot air is
fed to the dryer at 12 [m3(STP)/kg wet chips]. Wet- and dry-bulb thermometers are
mounted in both the inlet and the outlet air lines to indirectly monitor the moisture
contents of the exiting chips, which is determined by a material balance. After the
dryer achieves steady state, the inlet dry-bulb temperature was 100 [°C] and its wet-
bulb temperature was low enough so that the moisture contents of the incoming air
may be neglected. The dry-bulb temperature of the exiting air was 38 [°C], and the
wet-bulb temperature was 29 [°C].
State any assumptions:
Based on the information above, do or answer the following:
(a) Draw a diagram of the process.
(b) Use the attached psychrometric chart to estimate, for the outlet air: (i) the
absolute humidity, (ii) the dew point in [°C], (iii) the relative humidity, and
(iv) the enthalpy in [kJ/kg DA]. Locate the point on the chart.
(c) Determine the mass of water evaporated from the chips, in [kg/h].
(d) Estimate the moisture contents of the chips at the exit.
(e) Estimate the enthalpy of the incoming air, in [kJ/kg]. See hint below. (8 pts)
(f) If the dryer is adiabatic, estimate the exit temperature of the chips, in [°C].
Additional data and hints:
The reference state for dry air in the psychrometric chart is 0 [°C]. The heat capacity
of dry air is approximately 1 [kJ/kg-K]. The heat capacity of the dry chips is
approximately 2.1 [kJ/kg-K].