Exploiting the Linearity of Circuits - Superposition and
Proportionality Principles
OBJECTIVE:
â—» To verify the superposition theorem and proportionality principle in a DC circuit
EQUIPMENT:
DC power supplies(two)
DMM with probes
Resistors: R_(1)=6.8k\Omega _(,)R_(2)=5.6k\Omega _(,)R_(3)=10k\Omega _(,)R_(4)=10k\Omega _(,)R_(5)=1k\Omega
BACKGROUND:
The superposition theorem allows us to calculate the combined effects of a multi-source circuit
by summing the individual effects of each source acting alone. Attention must be paid to current
directions and voltage polarities when applying superposition. The circuit has two voltage
sources, V_(S1) and V_(S2). According to superposition theorem, voltages V1,V2,V3,V4 and V 5 and
currents I1, I2, I3, I4 and I5 can be calculated by taking their values due to individual source
acting alone, and then adding them. The voltage source not being considered is to be replaced
with a short circuit.
It is important to note that you must remove the power supply before you replace it with a short
circuit. Never short-circuit a functioning power supply. Also, pay attention to the polarity of
voltages due to each source so that you algebraically sum them to get the total.
Proportionality principle means that the output is proportional to the input (signals produced by
independent sources). An example of proportionality is a voltage divider. Proportionality
principle only works for circuits driven by a single independent source, and that this principle is
most effective for resistive ladder networks.