Download Cisco Packet Tracker from the list of tools and install it either in your computer or in a Windows virtual machine.1. Drag & drop a Cisco 2911 router. In the CLI, execute sh version. What is the configuration registers value?2. What the leading 0x means?3. According to this value, what bits are enabled? Write down the bit numbers or positions.4. What is the hexadecimal value for the boot field? What does it mean?5. Change the boot field to 0x00, but let all other bits unchanged. What command did you execute?6. Execute reload to restart the router. What the prompt looks like?7. From there, you will be able to completely boot with the command boot. Now set the register so that the boot field is 0x02, diagnostic messages are enabled and NVRAM content ignored; everything else unset or diabled. What value did you set?8. Execute again reload. Then, en and config t. What options do you have when executing boot ? (as listed below the command, one per line)?9. Verify the system flash from the CLI. Capture a screenshot of the command you used and its output.10. To show information about the IOS license in a real router you might use show license. However, this does not work in Packet Tracker. What command would you use to list all showing options beginning with l?