Numerade

Questions asked

BEST MATCH

Which of the following is true? Most insurance companies fund their activities by accepting insured deposits. Property loss risk is generally easier to estimate than liability loss risk. The National Association of Insurance Commissions (NAIC) examines and regulates insurance companies. None of the answers is correct. The federal government maintains a permanent reserve fund to resolve insurance companies' failures.

View Answer

BEST MATCH

Question 6.1 Find the time required for $ 12.5 \times $ $ 10^{18} $ electrons to leave the negative terminal of a battery if the current provided by the battery is 0.5 A . Question 6.2 One of the circuits in a small portable. CD player operates on a current ol 2.5 mA . Calculate the number of electrons that enter and leave the player in 1.0 s .

View Answer

BEST MATCH

(1) 11. (18 pts.) Consider the differential equation y' = 2xy - 4x. (a) Find all solutions of the differential equation (1). (b) Find the particular solution of the differential equation (1) which satisfies y(0) = 6.

View Answer

BEST MATCH

Task 1 Calculate the heat transfer rate for the following composite wall configurations: (A)Consider a composite plane wall that includes a 10 mm-thick hardwood siding, 50-mm by 120- mm hardwood studs on 0.7m centres with glass fiber insulation (paper faced, 28 kg/m3), and a 15 mm layer of gypsum wall board. What is the thermal resistance per unit area associated with this wall (having 10 studs, each 2.5 m high). In addition, given the temperature at the inlet and outlet surface is 20 C and -15 C, calculate the heat transfer rate though this wall. stud o Wood Siding 120mm insu lation o WalI board K 50mm (BStainless steel tube is used to transport pharmaceutical liquids,it has an inner diameter of 40 mm and a wall thickness of 4 mm. The pharmaceutical and ambient air are at temperatures of 6 C and 23C, respectively, while the corresponding inner and outer convection coefficients are 400 W/m2 .K and 6 W/m2 K, respectively. (a) What is the heat gain per unit length? (b) What is the heat gain per unit length if a 10 mm thickness layer of calcium silicate insulation (kins = 0.050 W/m. K) is applied to the tube? HTU aioillalla Al Hussein Technical Uni Page5of 8 Y=20mm F=22mm =23 =6Wm3:k n6= 6 insulation 400W/mk kin=O0.05W/mK hiz

View Answer

BEST MATCH

Problem 2. Given the SR flip-flop of Fig. P4.13a, complete the timing diagram of Fig. P4.13b by determining the waveform of the output $Q$. The condition $S = R = 1$ is produced twice by the inputs. Will this lead to unstable operation? Explain. Figure P4.13 (a) Flip-flop. (b) Timing diagram.

View Answer

BEST MATCH

In steam power plants, open feedwater heaters are frequently utilized to heat the feedwater by mixing it with steam bled off the turbine at some intermediate stage. Consider an open feedwater that operates at a pressure of 1600 kPa. Feedwater at 75 °C and 1600 kPa with 360 m/s is to be heated with steam at 400 °C and 1600 kPa and 750 m/s. In an ideal feedwater heater, the mixture leaves the heater as saturated liquid at feedwater pressure 20 m above the inlet lines at 100 m/s. if the heat loss is 1200 kJ/kg of steam, determine: 1. The ratio of the mass flow rate of the feedwater and the steam (7 marks) 2. The ratio of the mass flow rate of feedwater and exit stream (4 marks) 3. The diameter in mm of the feedwater flowing pipe if the feedwater flow rate is 1.5 kg/s (4 marks)

View Answer

BEST MATCH

Let A be a non-empty set, and let f: A â†’ A. Then f(C) âŠ† C if and only if C âŠ† f^(-1)(C).

View Answer

BEST MATCH

16. In the diagram, which of the following squares should be shaded to make BD a line of symmetry of square ABCD? (A) P and S (D) Q and T (B) Q and S (C) P and T (E) P and R

View Answer

BEST MATCH

Convert radians to degrees: $\frac{\pi}{4} = \underline{\qquad}$

View Answer

BEST MATCH

Multiply. Write the answer in simplest form.\\ $\frac{1}{8} \times \frac{5}{7} = \boxed{}$

View Answer

stephanie s.