Numerade

Questions asked

BEST MATCH

Which of the following is not one of the common assumptions typically used in break-even analysis? Variable costs fluctuate in a linear fashion. Revenues vary directly with volume. Fixed costs are ignored. Break-even analysis considers total costs rather than average costs.

View Answer

BEST MATCH

What is the formal charge of oxygen atom in the compound? :O: C :O: a. +2 b. +1 c. -1 d. -2

View Answer

BEST MATCH

If an excise tax is imposed on beer and collected from the producers, the _____ curve will shift _____ by the amount of the tax. Question 8 options: demand; upward demand; downward supply; downward supply; upward

View Answer

BEST MATCH

Question 25 (3 points) Listen Suppose we have the following values of $ Y_{t} $ (actual values) and the forecasted values of $ Y\left(\right. $ call them $ \left.F_{t}\right) $ : $ \begin{array}{lll}t & Y_{t} & F_{t}\end{array} $ $ 1 \quad 100 \quad 140 $ 2200160 What is the value of the mean forecast error (MFE)? Report your answer as a single whole number. $ \square $ A

View Answer

BEST MATCH

Given that the initial rate constant is 0.0140s−1 at an initial temperature of 29 ∘C , what would the rate constant be at a temperature of 140. ∘C for the same reaction described in Part A? Express your answer with the appropriate units.

View Answer

BEST MATCH

iving your rental car on your vacation in Europe, you find that you are getting 13.2 km/L of gasoline. What does this respond to in miles per gallon?

View Answer

BEST MATCH

3. A cardboard box is released to slide down a wooden ramp. The ramp is tilted at 28°; the kinetic coefficient of friction between the ramp and the box is $\mu_k = 0.34$. a) Draw the three forces acting on the box by adding them to the diagram. b) Define a suitable coordinate system. c) Complete the force equations and calculate the acceleration of the box down the ramp. 28°

View Answer

BEST MATCH

A modulating signal 10sin(2? x 10³t) is used to modulate a carrier signal 10sin(2? x 10?t). Find the modulation index, percentage modulation, frequencies of sideband components and their amplitudes and also determine the bandwidth of the modulating signal.

View Answer

BEST MATCH

Use this data for problems 8, 9, & 10: 9, 2, 5, 4, 5, 3, 5, 4, 6, 7 8 Calculate the Mean 9 Calculate the Sample Standard Deviation & Sample Variance (Assume that the data is sample data) 10 Calculate the Population Standard Deviation & Variance (Assume that the data is popoulation data)

View Answer

BEST MATCH

Question 5, Ch.26.1.23 In an amplified circuit, the current i (in A) changes with time t (in s) according to the equation below. If 0.065 C of charge has passed a point in the circuit at t=0, find the total charge to have passed the point at t=0.75s. $i = 0.06t\sqrt{1 + t^2}$

View Answer

timothy s.