Draw out a dilution scheme showing how you would perform a 1/450 dilution. Making sure that no more than 10mL is in each tube. Please show both tube and total dilutions.
Added by Julio R.
Step 1
To do this, take 1mL of the original solution and add it to 9mL of diluent. This gives us a total of 10mL in the tube. The dilution factor at this point is 1/10. Show more…
Show all steps
Your feedback will help us improve your experience
Anna D. and 83 other Biology educators are ready to help you.
Ask a new question
Labs
Want to see this concept in action?
Explore this concept interactively to see how it behaves as you change inputs.
Key Concepts
Recommended Videos
Calculate and Illustrate (draw) how you would make four serial 3-fold dilutions such that each tube has a volume of 6 mL. There should be at least 3 mL in each tube following the preparation of all dilutions, because that is a minimal requirement for this particular experimental setup. [HINT: Start with how to make 3-fold dilutions and scale-up to give sufficient, or extra, such that each tube will have at least 3 mLs at the end]
Jenny W.
How would you set up a series of 5 tubes with a 1:4 serial dilution, such that you end up with 3 mL of solution in each tube? What is the final dilution in each tube?
John N.
How many milliliters of water must be added to $150.0 \mathrm{~mL}$ of $2.50 \mathrm{M} \mathrm{KOH}$ to give a $1.00 \mathrm{M}$ solution? (Assume the volumes are additive.)
Recommended Textbooks
Biology for AP Courses
Objective Biology for NEET
Introduction to General, Organic and Biochemistry
Transcript
18,000,000+
Students on Numerade
Trusted by students at 8,000+ universities
Watch the video solution with this free unlock.
EMAIL
PASSWORD