00:01
So in this problem, we're going to look at some of the important descriptors of a wave.
00:04
So we have our waveform something like this.
00:09
And these are all equal, but a little more difficult to draw.
00:14
It's a voltage from 0 .8 volts to negative 0 .8.
00:20
And then each crossing here is at a 0 .2 second interval, 0 .4, 0 .6, and so on.
00:30
And so in the first place, we want to find the amplitude, which is a 0 .2 second interval, interval.
00:33
In general is from whatever average voltage is to the highest deviation from that.
00:39
So we can find that in general.
00:42
If we have some vmax here and some v minimum, we have a v not about which this wave transitions about.
00:53
So up above and below, we want to find that, so we can then find amplitude.
00:56
And we could see it would just be the average of the maximum and the minimum.
01:02
So v not is v max plus vmin.
01:08
Over 2 and we see it's 8 minus 8 over 2 so 0 volts and then the amplitude is going to be the difference between say the maximum and the minimum that keep our positive sign so it'll be 8 volts minus 0 to be 8 volt amplitude and we want to do this process because in this way we can pretty clearly see that it is 0 .8 but what if we had a wave some of up here between, say, 0 .8 and 1, well, what would be the amplitude be we need to calculate about where it vibrates.
01:54
In the next part, we want to take, this would be in part a, in the next part we want to take some instant readings, the voltage, and we can represent my parentheses here at 0 .3 seconds.
02:07
And so, of course, that is going to be in between our zero crossings.
02:13
And if it's right between like this is going to be at the amplitude because this wave is going to, this is a sign or cosine wave and so we bring just know directly that right in between the middle, we have our maximum or minimum at 0 .3 seconds, negative 8 volts, and at 0 .6 seconds, we see that this is directly at a zero crossing.
02:39
And so we have a voltage of 0.
02:46
In the next part, we want to find the peak to peak.
02:49
So is exactly what it says.
02:51
We take from one peak and find the distance to the nether.
02:56
Now here it's pretty easy to see.
02:58
Of course, this is 8 volts to 8.
03:03
Little overzealous there with these zeros.
03:06
And we can find peak to peak in a general sense by taking the maximum and subtracting the minimum.
03:22
And so in this case, we get 8 volts minus.
03:26
8 because minus negative 8, right? so 8 plus 8, 16 volts peak to peak.
03:41
And once again, if you remember the process, then we can directly tell when we have a wave in some general place, what would be it's peak to peak because we don't have a convenient, if we don't have a convenient one around the zero point like we did this time.
03:57
In the next part, we have the period, which is capital t, and it's the time to take the wave to complete one cycle.
04:03
So, whichever part of the wave we have, we want to find an equivalent part, and we can measure it.
04:11
By this point, we can also measure it from crossings, from say the zero crossing, which is a very convenient place to do it...