00:01
Okay, so we're doing in chapter 26, problem 23.
00:03
So we have three equal resistors of all big r, and they're connected to a battery shown in this circuit over here.
00:12
And we want to figure out, at least for part a, what happens to the voltage drop increase across each of these resistors.
00:25
And then b, we want to know what happens to the current through each of the resistors.
00:30
For c, we want to know the voltage of the resistors.
00:33
Battery when the switch s is opened after having been closed for a long time.
00:40
Okay, so let's figure out what the r effective for our circuit is when it's closed.
00:46
So this is the initial case, it says it's closed for a long time at first.
00:51
So if we look here, we got one loop here of these two resistors in series, and these two resistors here in parallel.
01:00
So if we add these up, then our total equivalence is going to be the internal resistance, which is in series with a resistor.
01:15
But this is in series with an equivalent resistor of 2 big r in parallel.
01:27
So this is what that equation looks like to figure out the equivalent resistance.
01:31
If we add all this up, this becomes r plus 3 1 times big r.
01:38
So this is what the effective resistance is closed.
01:41
And now when we open it, this changes, right? because now this second loop here that had the parallel resistance isn't connected anymore.
01:52
So this is just little r plus two big r resistors in series.
02:01
Okay.
02:03
So using oms law, we can figure out that the current when it's closed, and this is just the emf over the closed resistance.
02:18
And similarly, we also know that the current when it's open is emf over this resistance.
02:27
Okay, so part a was asking what is the resistance or the voltage drop across these resistors? so i'm going to go ahead and label these r1, r2, and r3, even though they all have the same resistance.
02:47
So first, let's talk about r3.
02:51
Well, this voltage is going to go to zero, right? because there's no current going through that resistor anymore.
02:59
So r3, the voltage and 3 goes to 0.
03:08
So that's one of them.
03:12
Okay.
03:14
Next, let's figure out for our voltage 1, what happens here.
03:22
So the voltage drop across the first resistor will decrease because we know that the current drops.
03:33
When we go from closed to open, our current drops, which means our voltage must drop.
03:41
So this decreases the voltage in one.
03:47
Okay, so let's now look at the voltage in the second resistor or the middle one.
03:54
Now, the voltage drop here, you might think would decrease because the total current decreased, but the current drop.
04:06
So current goes to less current, but it's not quite half the current, if that makes sense.
04:18
But the voltage is doubled.
04:24
And that's because we go from, if we just model this second loop here, we go from when it's open, the only resistance is just as one resistor are.
04:36
When it's closed, we have two r's in parallel, which comes out to be r over 2.
04:43
So if our resistance doubles, our current will decrease, but not quite by half.
04:53
So that means our voltage must increase in the second one...