Question

Name: Number: EE 309 Analog Electronics and Design Homework Spring 2022-2023 Duration: 25/04/2023 15:00 - 28/04/2023 15:00 Q1 Q2 Q3 Q4 TOTAL 25 25 25 25 100 1) a) As depicted in the figure, input voltage is 120 Volts (RMS) and diode drops are 0.7 Volts. Design this circuit with given two outputs and calculate turns ratio of transformer. i) 10 V ii) 100 V b) Consider a circuit using Si diodes and 10 k ohms resistors. Design this clipper circuit with output ranges below; i) -0.7 V and above ii) +2.1 V and above iii) 1.4 V c) As given in the figure a clamper circuit with the input signal Vi is proposed to design. Determine the output voltage with the exact solution step by step. Sketch transfer characteristic Vo versus Vi.

          Name:
Number:
EE 309 Analog Electronics and Design Homework
Spring 2022-2023 Duration: 25/04/2023 15:00 - 28/04/2023 15:00
Q1 Q2 Q3 Q4 TOTAL
25 25 25 25 100
1)
a) As depicted in the figure,
input voltage is 120 Volts
(RMS) and diode drops are
0.7 Volts. Design this circuit
with given two outputs and
calculate turns ratio of
transformer.
i) 10 V
ii) 100 V
b) Consider a circuit using Si diodes and 10 k ohms resistors.
Design this clipper circuit with output ranges below;
i) -0.7 V and above
ii) +2.1 V and above
iii) 1.4 V
c) As given in the figure a clamper
circuit with the input signal Vi is
proposed to design. Determine the
output voltage with the exact solution step by step. Sketch
transfer characteristic Vo versus Vi.

Name:
Number:
EE 309 Analog Electronics and Design Homework
Spring 2022-2023 Duration: 25/04/2023 15:00 - 28/04/2023 15:00
Q1 Q2 Q3 Q4 TOTAL
25 25 25 25 100
1)
a) As depicted in the figure,
input voltage is 120 Volts
(RMS) and diode drops are
0.7 Volts. Design this circuit
with given two outputs and
calculate turns ratio of
transformer.
i) 10 V
ii) 100 V
b) Consider a circuit using Si diodes and 10 k ohms resistors.
Design this clipper circuit with output ranges below;
i) -0.7 V and above
ii) +2.1 V and above
iii) 1.4 V
c) As given in the figure a clamper
circuit with the input signal Vi is
proposed to design. Determine the
output voltage with the exact solution step by step. Sketch
transfer characteristic Vo versus Vi.

Added by Matthew M.

Question

Please give Ace some feedback