Numerade

Questions asked

BEST MATCH

According to the Ebbinghaus forgetting curve, we forget most things within one __________________________. hour day week minute

View Answer

BEST MATCH

Learning Goal: To analyze and design a passive, first-order high-pass filter using a series $RC$ circuit. An instrument needs to detect periodic signals of approximately 5000 Hz. The instrument operates in an environment with a lot of periodic noise ranging from a few to several hundred hertz. A high-pass $RC$ filter can be built using available 2.0 µF capacitors; resistors of any necessary value are also available. ▷ Part A - Qualitative analysis of a series $RC$ low-pass filter Part B - Designing and analyzing a series $RC$ high-pass filter Using the available 2.0 µF capacitor, what is the value of the resistor needed to make a high-pass filter with a cutoff frequency of 2700 Hz? Express your answer to three significant figures and include appropriate units. ► View Available Hint(s) μΑ ? $R=$ Value Units Submit Part C - Measuring the effectiveness of the series $RC$ high-pass filter To measure the effectiveness of the design, find the magnitude of the output voltage of the series $RC$ high-pass filter for the given frequencies. Use an input voltage of 1 V. Express your answers, separated by commas, to three significant figures in units of volts. ► View Available Hint(s) Vout (60 Hz), Vout (2700 Hz), Vout (5000 Hz) = Submit ■ ΑΣΦ 11 vec? V, V, V

View Answer

BEST MATCH

Long-term organizations that do not participate in Medicare or Medicaid are regulated by: CMS the state the federal conditions of participation accreditation organizations

View Answer

BEST MATCH

The element is subjected to plane stress. To determine the normal stress over section AB the transformation equation shown is used. Which of the following is the correct angle to be used?\\ $\sigma'_x = \frac{\sigma_x + \sigma_y}{2} + \frac{\sigma_x - \sigma_y}{2} \cos 2\theta + \tau_{xy} \sin 2\theta$\\ -40 -70 20 40 -20 70

View Answer

BEST MATCH

10. Compute $\int \left( \frac{1}{x^3} - \frac{2}{x} - \sec^2 x \right) dx$

View Answer

BEST MATCH

B) local minimum: \begin{pmatrix} \frac{5\pi}{12}, \frac{5\pi - 6\sqrt{3}}{12} \end{pmatrix} local maximum: \begin{pmatrix} \frac{\pi}{12}, \frac{\pi + 6\sqrt{3}}{12} \end{pmatrix} inflection points: \begin{pmatrix} \frac{\pi}{4}, \frac{\pi}{4} \end{pmatrix} \begin{pmatrix} \frac{3\pi}{4}, \frac{3\pi}{4} \end{pmatrix} C) no local extrema inflection point: \begin{pmatrix} \frac{\pi}{2}, \frac{\pi}{2} \end{pmatrix}

View Answer

BEST MATCH

3. Find the end-effector velocity for the joint speeds given below. (5 points) dq/dt = [3, -2, 1]$^T$ rad/s

View Answer

BEST MATCH

In no-load phasor diagram of the transformer, the core loss component current is ____ with primary voltage. out of phase & parallel in phase Perpendicular & in phase Parallel & in phase In 3-phase system, if the three loads were identical in every way, then the currents flowing in the three lines would be _______

View Answer

BEST MATCH

Figure. VY ? Y 2 3E 38 Generator 30 MVA 20 MVA 11/22 kV 11 kV X = X = X = 0.12 pu X = X = 0.1 pu X = 0.15 pu Xn = 0.25 pu 4 1 + j5 10 MW 20 MVA 22/1.1 kV X = X = X = 0.05 pu

View Answer

BEST MATCH

The main difference between a servomotor and a standard conventional motor is that:

View Answer

consuelo s.